Thursday, June 22, 2017

Long Term Evolution - Mini Pulse Cult









Batman - fandom The Mini Pulse Hounder
First introduced into the Gotham mythos in the arc entitled 200 Miles to Memphis. Bruce Wayne who has been Locked-In to House of Owls has sent Robin to seek an imaginary weapon he has heard the Penguin has been using on homeless men in The Narrows to get a bit a 'strange "app-ed" pupil style.
Called the Mini Pulse Hounder this handheld Electro Magnetic Pulse(EMP) device that Robin creates as he is sick of following Batman's orders tracking down false leads.
Step 1:
purchase a old camera or old camera circuit that produces a camera flash
-most run on a 3V battery system.
- the capacitor in an old camera (one can find one on E Bay or in a number of rummage like shops
-be careful while taking out the circuit as the capacitor might still have stored charges.
{Attach a AA battery holder with the circuit. First find out the points in the circuit where the battery leads were connected before with the circuit. Solder the wires properly.}
Step 2:
a coil which does not cover much of the area of one's hand
-reference material suggested that a coil from an old SMPS circuit can be used but some "super hero" types suggest augmented copper wires.
Make sure that the winding of the copper wire is tight.
Step 3: Step 3: Getting Started, Making the Skeleton
think of one's hand as spiderman claw
just as one must think of an aggressor as an extension of one's capacitor
Affix the coil to the palm
with a metal strip backed by thick cardboard to provide the insulation to one's skin
-literature suggests one use a walkie-talkie or am radio antenna one can affixed to the palm-part with surgical or electrical tape.
*The point of fixing the antenna is to allow the palm to move freely. It should be flexible so that you can bend your hand properly.
Step 4: Adding the Vital Organs
Now that the skeleton is built attach the most important part, the camera circuit with cardboard
Step 5: Some More Bones for the Skeleton
*The whole structure should be so built that it stays on your hand. We have attached a metal strip before so that the coil stays on the palm. Now we have to attach another metal strip so that the circuit-part stays fixed on the forearm.
To make this happen literature suggests using a magnifying glass frame.
Step 6: the Source of Energy
Attach a AA battery holder with the circuit. First find out the points in the circuit where the battery leads were connected before with the circuit. Solder the wires properly.
Step 7: Attaching the Coil
First connect the wires properly with the coil. You can solder the wires with the coil. One wire is to be attached at the beginning of the coil, the other wire at the end of the coil.
These two wires are to be soldered with the two electrodes of the capacitor in the circuit.
Step 8: Finishing
-use insulating tape to attach the coil to the palm
-attach battery holder to the forearm-part with tape.

No comments:

Post a Comment